4-санға «Автоматтандыру және ақпараттық технологиялар», «Азық-түлік инженериясы және биотехнология», сондай-ақ «Химиялық технология» бағыттары бойынша мақалалар қабылдау жабылды.

Приём статей в четвёртый номер по направлениям «Автоматизация и информационные технологии», «Пищевая инженерия и биотехнология», а также «Химическая технология» закрыт.

Submissions for the fourth issue in the fields of Automation and Information Technology, Food Engineering and Biotechnology, as well as Chemical Technology, are now closed.

Preview

Bulletin of Shakarim University. Technical Sciences

Bulletin of Shakarim University. Technical Sciences

Advanced search

SIMULATION AND PERFORMANCE ANALYSIS OF PID-TYPE ITERATIVE LEARNING CONTROL IN THE LABORATORY LINE TESTING OF CYLINDRICAL CELL BATTERIES

https://doi.org/10.53360/2788-7995-2026-3(23)-29

Abstract

The increasing demand for reliable rechargeable energy storage systems has strengthened the need for accurate laboratory testing procedures for cylindrical cell batteries. Laboratory and pilot-line testing stations repeatedly perform charging, discharging, voltage verification, capacity estimation, and internal resistance measurements. These operations require precise current and voltage regulation because even small transient deviations may affect cell classification, aging analysis, and safety evaluation. This work presents a simulation-based study of PID-type Iterative Learning Control (PID-type ILC) for repeated laboratory line testing of cylindrical cell batteries. The proposed approach combines the classical proportional-integralderivative control structure with an iterative learning mechanism that updates the control input after each repeated cycle using the previous tracking error. A simplified MATLAB model of a cylindrical battery charging process was developed using state-of-charge dynamics, internal resistance, terminal voltage estimation, actuator saturation, and a repeated finite-time testing interval. The simulation evaluates the controller response over successive cycles and analyzes current tracking, voltage behavior, control effort, state of charge, and error convergence. The results demonstrate that PID-type ILC can reduce tracking error over repeated cycles and improve the repeatability of laboratory battery testing. The method is especially relevant for automated quality-control lines where many cells are tested under similar protocols. The proposed simulation can serve as a preliminary digital model before experimental implementation on a real battery testing bench.

About the Authors

S. N. Uali
Scientific Center for New Technologies; International IT University
Kazakhstan

Shynybek Nakhypbekuly Uali – Student, Department of Mathematical Computer Modeling, Faculty of Computer Technology and CyberSecurity

Almaty, Al-Farabi 7k, Nurly Tau Business Center, Block 5A, 334b, 050059, Kazakhstan

34/1 Manasa str., Bostandyk district, Almaty, Kazakhstan, 050040



A. B. Seisenova
Scientific Center for New Technologies; AlAkSan
Kazakhstan

Aknur Berdibayevna Seisenova – PhD

Almaty, Al-Farabi 7k, Nurly Tau Business Center, Block 5A, 334b, 050059, Kazakhstan 

Al-Farabi 7k, Nurly Tau Business Center, Block 5A, 334b, 050059, Kazakhstan



O. S. Kapizov
Scientific Center for New Technologies; AlAkSan
Kazakhstan

Omirzak Sembiuly Kapizov 

Almaty, Al-Farabi 7k, Nurly Tau Business Center, Block 5A, 334b, 050059, Kazakhstan 

Al-Farabi 7k, Nurly Tau Business Center, Block 5A, 334b, 050059, Kazakhstan



D. K. Mukhanov
Scientific Center for New Technologies; Al-Farabi Kazakh National University
Kazakhstan

Dauren Kabdrakimovich Mukhanov – Department of Chemistry and Chemical Technology

Almaty, Al-Farabi 7k, Nurly Tau Business Center, Block 5A, 334b, 050059, Kazakhstan

71 al-Farabi Avenue, Almaty, 050040



K. R. Manap
Scientific Center for New Technologies; AlAkSan
Kazakhstan

Kalima Rakhymbekkyzy Manap – Researcher

Almaty, Al-Farabi 7k, Nurly Tau Business Center, Block 5A, 334b, 050059, Kazakhstan 

Al-Farabi 7k, Nurly Tau Business Center, Block 5A, 334b, 050059, Kazakhstan



References

1. Scrosati B. Lithium batteries: Status, prospects and future / B. Scrosati, J. Garche // Journal of Power Sources. – 2010. – № 195(9). – Р. 2419-2430. https://doi.org/10.1016/j.jpowsour.2009.11.048.

2. Goodenough J.B. The Li-ion rechargeable battery: A perspective / J.B. Goodenough, K. Park // Journal of the American Chemical Society. – 2013. – № 135(4). – Р. 1167-1176. https://doi.org/10.1021/ja3091438.

3. Zhu Z. The rational design of biomass-derived carbon materials towards next-generation energy storage: A review / Z. Zhu, Z. Xu // Renewable and Sustainable Energy Reviews. – 2020. – № 134, Article 110308. https://doi.org/10.1016/j.rser.2020.110308.

4. Arimoto S. Bettering operation of robots by learning / S. Arimoto, S. Kawamura, F. Miyazaki // Journal of Robotic Systems. – 1984. – № 1(2). – Р. 123-140. https://doi.org/10.1002/rob.4620010203.

5. Bristow D.A. A survey of iterative learning control / D.A. Bristow, M. Tharayil, A.G. Alleyne // IEEE Control Systems Magazine. – 2006 – № 26(3). – Р. 96-114. https://doi.org/10.1109/MCS.2006.1636313.

6. Polynomial Iterative Learning Control (ILC) Tracking Control Design for Uncertain Repetitive Continuous-Time Linear Systems Applied to an Active Suspension of a Car Seat / S.B. Attia et al // Mathematics. – 2024. – № 12(16). – Р. 2573. https://doi.org/10.3390/math12162573.

7. Elkholy M.M. Modern Control Techniques and Operational Challenges in Permanent Magnet Synchronous Motors: A Comprehensive Review / M.M. Elkholy, M.M. Algendy, E.A. El-Hay // Automation. – 2025. – № 6(4). – Р. 49. https://doi.org/10.3390/automation6040049.

8. Nise N.S. Control systems engineering (7th ed.). Wiley. 2015.

9. MathWorks. (n.d.). MATLAB and Simulink documentation for control system design and simulation. MathWorks. https://www.mathworks.com/help/slcontrol/index.html.

10. Plett, G.L. Battery Management Systems, Volume I: Battery Modeling. Artech House, Norwood, MA. 2015.

11. Electrochemical modeling in lithium batteries: Pathways to next-generation power sources / Hosein Jahangir et al // Journal of Power Sources. – 2025 – Vol. 654. https://doi.org/10.1016/j.jpowsour.2025.237833.

12. Albakri M. A Review of Modelling, State of Charge Estimation and Management Methods of EV Lithium-Ion Batteries / M. Albakri, A. Darwish // Batteries. – 2026. – № 12(3). – Р. 92. https://doi.org/10.3390/batteries12030092.


Review

For citations:


Uali S.N., Seisenova A.B., Kapizov O.S., Mukhanov D.K., Manap K.R. SIMULATION AND PERFORMANCE ANALYSIS OF PID-TYPE ITERATIVE LEARNING CONTROL IN THE LABORATORY LINE TESTING OF CYLINDRICAL CELL BATTERIES. Bulletin of Shakarim University. Technical Sciences. 2026;(3(23)):312-321. https://doi.org/10.53360/2788-7995-2026-3(23)-29

Views: 13

JATS XML


Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 License.


ISSN 2788-7995 (Print)
ISSN 3006-0524 (Online)
X