4-санға «Автоматтандыру және ақпараттық технологиялар», «Азық-түлік инженериясы және биотехнология», сондай-ақ «Химиялық технология» бағыттары бойынша мақалалар қабылдау жабылды.

Приём статей в четвёртый номер по направлениям «Автоматизация и информационные технологии», «Пищевая инженерия и биотехнология», а также «Химическая технология» закрыт.

Submissions for the fourth issue in the fields of Automation and Information Technology, Food Engineering and Biotechnology, as well as Chemical Technology, are now closed.

Preview

Bulletin of Shakarim University. Technical Sciences

Bulletin of Shakarim University. Technical Sciences

Advanced search

INVESTIGATION OF THERMAL PROCESSES DURING DETONATION SPRAYING OF CAPILLARYPOROUS COATINGS

https://doi.org/10.53360/2788-7995-2026-3(23)-62

Abstract

Heat loads for porous coatings of natural materials were studied as a function of their properties. From 26 investigated combustion chambers and nozzles, a device was selected and a powder-and-thermite feed scheme was developed for spraying onto metallic surfaces. Coatings were deposited at an oxidizer excess coefficient α < 1, with fuel afterburning occurring at the coating surface via supersonic pulsating hightemperature detonation jets issuing from the combustion chambers and nozzles. Specific heat fluxes at the coating surface were at least twice as high as those from conventional jets. The detonation phenomenon simultaneously acts as a hardening technology for coating formation. Structural spinning detonation consisting of seven zones was observed; the transverse velocity inclination angle approached 45°, and the velocity magnitude was close to the detonation velocity. Pressure oscillation frequency at the coating surface was approximately 200 Hz. Porous surfaces exhibited higher critical loads and were well controllable in limiting regimes. Thermotechnical evaluation confirmed their advantages over conventional systems. A model of detonation wave interaction with the coating was developed and coating temperature was determined.

About the Authors

A. A. Genbach
Almaty University of Power Engineering and Telecommunications n.a. G. Daukeev
Kazakhstan

Alexander Genbach – d.t.s., prof. dep. «Thermal Power and Physics»

050013, Republic of Kazakhstan, Almaty, Baitursynov str., 126/1


Competing Interests:

Авторы заявляют об отсутствии конфликта интересов



D. Yu. Bondartsev
Almaty University of Power Engineering and Telecommunications n.a. G. Daukeev
Kazakhstan

David Bondartsev – PhD, prof. dep. «Thermal Power and Physics»

050013, Republic of Kazakhstan, Almaty, Baitursynov str., 126/1


Competing Interests:

Авторы заявляют об отсутствии конфликта интересов



M. D. Yerbolatov
Almaty University of Power Engineering and Telecommunications n.a. G. Daukeev
Kazakhstan

Maulen Duissenbekuly Yerbolatov – PhD student dep. «Thermal Power and Physics»

050013, Republic of Kazakhstan, Almaty, Baitursynov str., 126/1


Competing Interests:

Авторы заявляют об отсутствии конфликта интересов



References

1. Firoozi A.A. Advancing durability in the energy sector: Novel high-temperature resistant coatings and their challenges / A.A. Firoozi, A.A. Firoozi, T. Saidani, // Ain Shams Engineering Journal. – 2025. – Vol. 16. – P. 103431. https://doi.org/10.1016/j.asej.2025.103431.

2. Vaßen R. A Perspective on Thermally Sprayed Thermal Barrier Coatings: Current Status and Trends / R. Vaßen, E. Bakan, Mack, D.E. // Journal of Thermal Spray Technology. – 2022. – Vol. 31. – Р. 685-698. https://doi.org/10.1007/s11666-022-01330-2.

3. Zhong Z. Mechanical properties and fracture modes of an advanced Ni–Co-base disk superalloy at elevated temperatures / Z. Zhong, Y. Gu, Y. Yuan // Materials Characterization. – 2012. – Vol. 67. – Р. 101-111. https://doi.org/10.1016/j.matchar.2012.02.021.

4. Zhang J.X. Dependence of creep strength on the interfacial dislocations in a fourth generation SC superalloy TMS-138 / J.X. Zhang, T. Murakumo, H. Harada // Scripta Materialia. – 2003. – Vol. 48. – Р. 287-293. https://doi.org/10.1016/S1359-6462(02)00379-2.

5. Zhang J.X. Thermomechanical fatigue mechanism in a modern single crystal nickel base superalloy TMS-82 / J.X. Zhang, H. Harada, Y. Ro // Acta Materialia. – 2008. – Vol. 56. – Р. 2975-2987. https://doi.org/10.1016/j.actamat.2008.02.035.

6. Yang X. Turbine platform phantom cooling from airfoil film coolant, with purge flow / X. Yang, Z. Liu, T. Simon // International Journal of Heat and Mass Transfer. – 2019. – Vol. 140. – Р. 25-40. https://doi.org/10.1016/j.ijheatmasstransfer.2019.05.109.

7. Arai M. Porous Ceramic Coating for Transpiration Cooling of Gas Turbine Blade / M. Arai, T. Suidzu // Journal of Thermal Spray Technology. – 2013. – Vol. 22. – Р. 690-698. https://doi.org/10.1007/s11666-013-9883-1.

8. Dhairiyasamy R. Enhancing biodiesel engine efficiency through tungsten carbide ceramic coatings: a performance and emission optimization study / R. Dhairiyasamy, D. Varshney, S. Singh // Discover Mechanical Engineering. – 2025. – Vol. 4. – P. 29. https://doi.org/10.1007/s44245-025-00114-6.

9. Bagathi M.R. O. Coating Characteristics of Plasma-Sprayed Ceramic Thermal Barrier Coatings on Internal Diameter (ID) Surfaces / M.R. Bagathi, R. Vaßen, O. Guillon // Journal of Thermal Spray Technology. – 2025. – Vol. 34. – Р. 2918-2938. https://doi.org/10.1007/s11666-025-02042-z.

10. Khan S.A. Design, fabrication and nucleate pool-boiling heat transfer performance of hybrid micro-nano scale 2-D modulated porous surfaces / S.A. Khan, N. Sezer, M. Koç, // Applied Thermal Engineering. – 2019. – Vol. 153. – Р. 168-180. https://doi.org/10.1016/j.applthermaleng.2019.02.133.

11. Experimental studies of natural material-based coatings for thermal protection of metallic surfaces / А.А. Genbach et al // Journal of Materials Science: Materials in Engineering. – 2025. – Vol. 20. – P. 46. https://doi.org/10.1186/s40712-025-00252-5.

12. Boiling crisis in porous structures / А.А. Genbach et al // Energy. – 2022. – Vol. 259. – P. 125076. https://doi.org/10.1016/j.energy.2022.125076.


Review

For citations:


Genbach A.A., Bondartsev D.Yu., Yerbolatov M.D. INVESTIGATION OF THERMAL PROCESSES DURING DETONATION SPRAYING OF CAPILLARYPOROUS COATINGS. Bulletin of Shakarim University. Technical Sciences. 2026;(3(23)):618-626. (In Russ.) https://doi.org/10.53360/2788-7995-2026-3(23)-62

Views: 14

JATS XML


Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 License.


ISSN 2788-7995 (Print)
ISSN 3006-0524 (Online)
X